telecom • networking • design

an EventHelix.com blog

LTE Attach and Default Bearer Setup Sequence Diagram

Leave a comment

LTE Attach and Default Bearer Setup

Click to open the PDF sequence diagram describing LTE attach and default bearer setup

This call flow describes the signaling involved in LTE attach and default bearer setup. The sequence diagram covers the following phases:

  1. Random Access Procedure: The UE uses a slotted aloha procedure to access the eNodeB. The UE sends a preamble on a random access channel, the network replies with corrected timing and resource assignments.
  2. RRC Connection Establishment: The UE and the eNodeB then interact to establish a Signaling Radio Bearer (SRB). The SRB will be used for the signaling between the eNodeB and the UE.
  3. Attach and Authentication: The UE now registers with the Core Network. Session contexts are setup at the MME and the Serving Gateway. This step also results in the authentication of the UE and the Network.
  4. Default Radio Bearer Setup: Finally, the default bearer for data transfer is established. Default bearer session is established at the UE, eNodeB, MME, Serving GW and PDN Gateway. User data sessions is exchanged once the default bearer is setup.

The sequence diagram also contains links to access further details about the messages. Click on the messages with blue title for details about the message.

RRC Connection, LTE Attach and Default Radio Bearer Setup

 

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s